< Previous  | TOC | Index | Next  >

Modifying configuration files on each remaining node

Perform the following tasks on each of the remaining nodes of the cluster.

 To modify the configuration files on a remaining node

1. If necessary, modify the /etc/gabtab file.

   No change is required to this file if the /sbin/gabconfig command has only the argument -c, although Symantec recommends using the -nN option, where N is the number of cluster systems.

   If the command has the form /sbin/gabconfig -c -nN, where N is the number of cluster systems, then make sure that N is not greater than the actual number of nodes in the cluster, or GAB does not automatically seed.

   ---

     Note   Symantec does not recommend the use of the -c -x option for /sbin/gabconfig. The Gigabit Ethernet controller does not support the use of -c -x.

   ---

2. Modify /etc/llthosts file on each remaining nodes to remove the entry of the leaving node.

   For example, change:

   0 A

   1 B

   2 C

   to:

   0 A

   1 B